Genesis GMS15LB - Depth of Cut and Squaring Adjustments; Depth of Cut Adjustment; Squaring the Saw Blade to the Fence

FIG 5
b
a
FIG 6
c 7
English
10" Compound Laser Miter Saw
Operator’s Manual GMS15LB
DEPTH OF CUT ADJUSTMENT
WARNING: Be sure the machine is unplugged from the power source. Accidental saw start-up could result in
serious personal injury.
NOTE: Your Miter Saw should come adjusted properly for depth of cut while using the Factory-installed blade for
normal operation.

.
To adjust the miter saw blade’s cutting depth
NOTE: This is factory set and usually does not require adjusting. (This saw may not come with the necessary tools for
the following procedure.)
 
 
 

 

 
 

WARNING: Whenever installing a new blade, always be sure that the new blade does not contact any part of
the machine’s metal base when the handle is completely lowered. Perform this test with the tool unplugged from the
power source.
SQUARING THE SAW BLADE TO THE FENCE

WARNING: Be sure that the tool is switched off and unplugged from the power source before performing any
work on the tool. Failure to unplug the saw may result in accidental start-up, causing possible serious personal injury.
 
 
 
 
 

 
 
 
 


0° AND 45° BEVEL STOP ADJUSTMENTS
NOTE: This is factory set and usually does not require adjusting. (This saw may not come with the necessary tools for
the following procedure.)
WARNING: Be sure that the tool is switched off and unplugged from the power source before performing any
work on the tool. Failure to unplug the saw may result in accidental start-up, causing possible serious personal injury.