Genesis GMS15LB - Assembly and Adjustments; Initial Assembly Steps

FIG 1
a
10
FIG 2
b
23
19
FIG 3
FIG 4
d
e
15
English
10" Compound Laser Miter Saw
Operator’s Manual GMS15LB
ASSEMBLY AND ADJUSTMENTS
WARNING: DO NOT connect your compound miter saw to the power source until the machine is
completely assembled, all necessary adjustments made, and you have read and understand the entire operator’s
manual.


DUST BAG





SUPPORT EXTENSION WINGS


REAR SUPPORT FOOT BAR


LASER BATTERY COMPARTMENT


WORK CLAMP
WARNING: In some operations, the work clamp assembly may interfere with the operation of the blade
guard assembly. Always make sure there is no interference with the blade guard prior to beginning any cutting
operation to reduce the risk of serious personal injury.





NOTE: Depending on the cutting operation and the size of the work piece, it may be necessary to use a C-clamp
instead of the work clamp to secure the work piece prior to making the cut.