Genesis GMS15LB - Cutting Warped Workpieces and Blade Maintenance; Saw Blade Installation or Removal

a b c
FIG 13
FIG 14
FIG 15
d
English
10" Compound Laser Miter Saw
Operator’s Manual GMS15LB
Left side, outside corner




Right side, outside corner




CUTTING WARPED WORKPIECES
Note: It is recommended that you do not cut warped material.



WARNING:
To avoid possible serious personal injury and possible kickback, never place the concave portion of bowed or warped
material against the fence.
MAINTENANCE
SAW BLADE INSTALLATION OR REMOVAL
WARNING: Be sure that the tool is switched off and unplugged from the power source before performing any
work on the tool.
WARNING: Use only 10” diameter saw blades that have 5/8” diameter arbor holes and are rated for speeds
equal to or greater then the nameplate rated RPM of this miter saw.
WARNING: Use only blades designed for cross-cutting operations.
WARNING: Do not use thin kerf blades with deep gullets which may deflect and contact the blade guards or
produce poor quality cuts in the work piece.
To remove the blade
 
 
 
 
 
 
 

 

