Need help?Do you have a question about the Genevac HT Series and is the answer not in the manual?
Details the physical remote control unit, its buttons, and LED indicators for system status.
Explains the warning symbols used in the manual for personal injury and material damage.
Instruction to perform a risk assessment for each solvent before use, referencing MSDS.
Lists safety precautions for operating the system in PURGE mode, including hose checks and ventilation.
Describes the power-up sequence, checking the POWER LED and inert gas supply.
Explains how to set the system to PURGE mode using the key switch and the N2OK LED indicator.
Details how to operate the system in NORMAL (non-purge) mode using the key switch.
Identifies and describes the function of each button and LED indicator on the remote control unit.
Checks to perform before starting an evaporation run, including condenser and N2OK LED status.
Step-by-step guide on initiating an evaporation run using the remote control and evaporator.
Explains manual and automatic stopping of the evaporator and the venting process.
Details the automatic power-down sequence of the purge system when the evaporator is switched off.
Weekly checks on hoses and periodic verification of purge and must run times.
Emphasizes installation by trained personnel and provides warnings about suffocation and solvent auto-ignition.
Illustrates hose and electrical cable connections for HT-4X and HT-8/12SII evaporation systems.
Details the specific ports on the purge box for gas supply, remote control, filter drain, and exhausts.
Illustrates how to connect the pump bleed and chamber exhaust hoses to nXDS6i and XDS5 vacuum pumps.
Explains system behavior based on N2OK, RESET, and FAULT LED indicators.
Procedure to re-start a purge cycle after rectifying a fault, ensuring it completes from the beginning.
Provides key specifications including dimensions, purge times for different models, operating environment, and inert gas supply details.
Details voltage, frequency, and peak current requirements for USA, Europe, and Japan.
Specifies suitable inert gases (Nitrogen or Argon) and advises consulting the distributor for alternatives.
Visual representation of the inert gas purge system connections and flow paths within the evaporator setup.
Declaration of conformity for HT-8SII & HT-12SII evaporators with EU health, safety, and EMC directives.
Details the 12-month warranty period, conditions for repair, and exclusions like accidental damage.
Records changes made to the manual across different issues, including dates and reasons for revision.
Provides contact information for Genevac, advice on keeping the manual, and proper disposal of equipment.
General| Brand | Genevac |
|---|---|
| Model | HT Series |
| Category | Laboratory Equipment |
| Language | English |
To Next Page
