9
For Help, call 1-800-35-GENIE or visit www.geniecompany.com
LEARN
CODE
BUTTON
LEARN
INDICATOR
LIGHT
A Install a light bulb (100 Watts or less)(not included) into Light
Socket (Figure 14):
• Rough service, 130 Volt bulbs are recommended.
B Install Lens into slots in Motor Cover.
• Insert Bottom hinges into slots provided in metal front
cover of Power Head.
• Flip Lens up and fasten with molded latches on lens.
iN S t a l l a t i o N o f le N S a N D bu l b
Figure 14 Install Lens and Light bulb
Transmitter Compliance Statement
WARNING
TO REDUCE THE RISK OF
SEVERE INJURY OR DEATH
1 READ AND FOLLOW ALL INSTRUCTIONS.
2 Never let children operate or play with the Door
Controls. Keep the Remote Control away from children.
3 Always keep the moving door in sight and away from
people and objects until the door is completely closed.
NO ONE SHOULD CROSS THE PATH OF THE
MOVING DOOR.
4 NEVER GO UNDER A STOPPED, PARTIALLY
OPEN DOOR.
5 Test Opener monthly. The door MUST reverse on
contact with a 1-1/2” high object (or a 2” x 4” board
laid flat) at the center of the doorway on the floor. After
adjusting either the Force or the Limit of travel, retest
the Door Opener. Failure to adjust the Opener properly
may cause severe injury or death.
6 When possible use the Emergency Release only when
the door is closed. Use caution when using this Release
with the door open. Weak or broken springs are capable
of increasing the rate of door closure and increasing the
risk of severe injury or death.
7 KEEP GARAGE DOORS PROPERLY BALANCED. See
Owner’s Manual. An improperly balanced door increases
the risk of severe injury or death. Have a Genie Factory
Authorized Dealer make repairs to cables, spring
assemblies, and other hardware.
8
SAVE THESE INSTRUCTIONS.
IMPORTANT SAFETY INSTRUCTIONS
No t e S
To Next Page
Loading...
Need help?
General
