Genie Aladdin Connect Quick Setup Guide

WARNING
UNPLUG GARAGE DOOR OPENER PRIOR TO INSTALLING
ALADDIN CONNECT™
Door may operate unexpectedly.
AVERTISSEMENT
DÉBRANCHER L’OUVRE-PORTE DE GARAGE AVANT
D’INSTALLER ALADDIN CONNECT™
La porte peut fonctionner de façon inattendue.
STEP 3
In the Garage:
These factors must be determined prior to mounting Aladdin Connect™
(DCM) to the wall or ceiling.
1. Optimal Wi-Fi signal strength.
• Ifanoptimalsignalcannotbelocatedwithinthegarage,movethewirelessroutercloserto
thegarageorinstallaWi-Firangeextender(availablefrommostelectronicstores)
2. Desired DCM location.
3. Access to 110VAC outlet within 5 feet.
1. Plug Power Pack into wall outlet and DCM near the chosen mounting
location.
The WI-FI signal indicator LED should illuminate signaling that the Wi-Fi
signal is still in tact.
• A GREEN LED indicates a good Wi-Fi signal.
• A YELLOW LED, indicates a weak signal. Move Aladdin
Connect™ to a position that better suits the Wi-Fi
signal from the router.
• A RED LED, indicates a lost or faulty signal. Move
Aladdin Connect™ to a position that better suits the
Wi-Fi signal from the router. Contact Customer Service
for further assistance. (1-800-599-4995)
2. Once an optimal signal and location is obtained,
UNPLUG POWER PACK from the DCM and continue to
STEP 4.
Wi-Fi Signal Indicator
GOOD -- WEAK -- POOR
DPS Signal
Red/Blue LEDs

Genie Aladdin Connect Specifications

General

Connectivity Protocol	Wi-Fi
Frequency Band	2.4 GHz
Wireless Standard	IEEE 802.11 b/g/n
Mobile App Support	Yes
Operating Temperature	-4°F to 122°F (-20°C to 50°C)