Genie GS-2669 User Manual (English)

Other manuals for Genie GS-2669

Questions and Answers:

C
Cristina BradyAug 4, 2025
How to fix Genie GS-2669 Scissor Lifts that cannot lift rated load?
- M
  Maria OsborneAug 4, 2025
  If your Genie Scissor Lift cannot lift the rated load, the relief valve might be set too low. In this case, increase the relief valve pressure.
C
Cody BushAug 13, 2025
What to do if Genie GS-2669 alarm continues to sound at max height with rated load?
- C
  Courtney ColemanAug 14, 2025
  If the pressure switch alarm continues to sound when your Genie Scissor Lift is at maximum height with the rated load, there are several potential causes. First, try resetting the system by turning off the red emergency stop button, waiting three seconds, and then turning the machine back on. Other possible solutions include: adjusting the up limit switch slightly lower or replacing the contacts, ensuring the correct rated load is in the platform, adjusting the pressure switch by turning the nut 1/4 turn into the hydraulic line, fully charging the batteries, repeating the calibration procedure for the overload system, or lubricating the slider channel.
C
cwilsonAug 25, 2025
What to do if Genie GS-2669 alarm continues to sound at down limit with rated load?
- M
  Michael RodriguezAug 25, 2025
  If the pressure switch alarm continues to sound when your Genie Scissor Lift is at the down limit with the rated load, there are several possible reasons. You can try to reset the system by turning off the red emergency stop button, waiting three seconds, and then turning the machine back on. Also, consider raising the down limit switch. Make sure the correct rated load is in the platform. You might also need to adjust the pressure switch by turning the nut 1/4 turn into the hydraulic line or repeat the calibration procedure.