Genie S-65 - Traction Manifold Components, 4 WD (from SN 21001 to 21231)

4 - 60 S-60 • S-65 • S-60 TRAX • S-65 TRAX Part No. 147753
S-60 HC • S-60X • S-60XC
December 2013Section 4 • Repair Procedures
7-12
Traction Manifold Components, 4WD (from SN 21001 to 21231)
The traction manifold is mounted inside the drive chassis at the non-steer end.
Index Schematic
No. Description Item Function Torque
1 Check valve ....................................... TT ......... Steer end drive motor circuit ............ 35-40 ft-lbs / 14-16 Nm
2 Check valve ....................................... SS ......... Non-steer end drive motor circuit ..... 35-40 ft-lbs / 14-16 Nm
3 Flow divider/combiner valve ............. AB ......... Controls flow to flow
divider/combiner valves
11 and 13 ...................................... 80-90 ft-lbs / 108-122 Nm
4 Check valve ....................................... AF ......... Non-steer end drive motor circuit ..... 60-70 ft-lbs / 81-95 Nm
5 Orifice, 0.040 inch / 1 mm .................. AC ........ Equalizes pressure on both sides
of flow divider/combiner valve 3
6 Orifice, 0.040 inch / 1 mm .................. AE ......... Equalizes pressure on both sides
of flow divider/combiner valve 11
7 Orifice, 0.040 inch / 1 mm .................. WW ....... Equalizes pressure on both sides
of flow divider/combiner valve 13
8 Check valve ....................................... AG ........ Steer end drive motor circuit ............ 60-70 ft-lbs / 81-95 Nm
9 Check valve ....................................... ZZ ......... Steer end drive motor circuit ............ 35-40 ft-lbs / 14-16 Nm
10 Shuttle valve, 3 position 3 way ......... VV ......... Charge pressure circuit that
directs hot oil out of low pressure
side of drive pump ........................ 80-90 ft-lbs / 108-122 Nm
11 Flow divider/combiner valve ............. AD ........ Controls flow to steer end
drive motors in forward
and reverse ................................... 80-90 ft-lbs / 108-122 Nm
12 Check valve ....................................... YY ......... Non-steer end drive motor circuit ..... 35-40 ft-lbs / 14-16 Nm
13 Flow divider/combiner valve ............. XX ......... Controls flow to non-steer end
drive motors in forward
and reverse ................................... 80-90 ft-lbs / 108-122 Nm
14 Relief valve, 280 psi / 19.3 bar ......... UU ........ Charge pressure circuit .................... 35-40 ft-lbs / 14-16 Nm
MANIFOLDS