Error! Use the Home tab to apply 标题 1 to the text that you
want to appear here.
48 FA50 Operation Manual
5.8.2.2Correct
In the “Item Set” menu, click the “Correct” button and select the
item to be calibrated. Taking PCT as an example, click the PCT
item, as shown in Fig. 5-8-10. In the reference range input box, you
can enter the correction parameters according to the actual
situation, and click the “Reset” button to restore the correction
parameters to the initial values.
Fig. 5-8-10
Calibration method
The analyzer has been calibrated before it is shipped from the
factory. Calibration coefficient is defaulted to be 1 and needs no
changes. If necessary, you can calibrate the coefficient according
to the following method:
To Next Page
Loading...