Geometrics Inc. G-882 Cesium Marine Magnetometer Page
<Alt F1> = Toggle graphics display of Grad1 on/off. Gradient channel 1 is
the
difference between Mag1 and Mag2. This key has effect in
graphics mode only.
<Alt F2> =
Same as <Alt F1> except it applies to Grad2 channel.
<Alt F3> =
Same as <Alt F1> except it applies to Grad3 channel.
<Shft F1>= Change graphics display color for Mag1. Press this key several
times to cycle through the 16 colors available for displaying
mag1.
Note that the display indicator for Mag 1 in the lower left hand
corner of the graphics display changes as well, aiding in
identifying
which trace belongs to which variable. This key only has effect in
graphics mode.
<Shft F2>= Same as <Shft F1> except it applies to Mag2 channel.
<ShftF3> = Same as <Shft F1> except it applies to Mag3 channel.
<Ctl F1> = Change graphics display color for Grad1 trace. Press this key
several times to cycle through the16 colors available for
displaying
Grad1. Note that the display indicator for Grad1 in the lower right
hand corner of the graphics display changes as well, aiding in
identifying which trace belongs to which variable. This key only
has effect in graphics mode.
<Ctl F2> = Same as <Ctl F1> except it applies to Grad2 channel.
<Ctl F3> = Same as <Ctl F1> except it applies to Grad3 channel.
<F4> = Toggle between true and normalized gradient display. When
measuring gradients it often desirable to center the display trace
to
the center of the screen so that small variations do not cause
screen wrapping. Pressing F4 will calculate and add an offset
value to force the gradient display traces to the center. Pressing
F4 again will toggle back to absolute display mode. Note that the
Grad display indicators in the lower right hand corner of the
graphics display screen change from "Gradx" to " "GradZx"
indicating the current mode. Note that this normalizing only takes
place on gradient channels.
<Alt F4> = Toggle true and normalized w. offset grad display. When
To Next Page
Loading...
Need help?
General