Geometrics G-882 User Manual

Geometrics Inc. G-882 Cesium Marine Magnetometer Page
60
measuring gradients with all three gradient channels turned on it
is
often desirable to move the three gradient traces close to the
center of the display - but not place them right on top of each
other. This key works the same as F4 above but leaves the
traces
slightly offset from one another.
<F5> = Toggle between graphics and text display mode.
<F6> = Lower the magnetometer full scale coefficient in the graphics
display window. This key only affects the Mag channels (not
gradient).
<F7> = Raise the magnetometer full scale coefficient in the graphics
display window. This key only affects the Mag channels (not
gradient).
<Alt F6> = Lower the Grad full scale coefficient in the graphics display
window. This key only affects the Grad channels (not
magnetometer).
<Alt F7> = Raise the Grad full scale coefficient in the graphics display
window. This key only affects the Grad channels (not
magnetometer).
<F8> = Clear next graphics screen and jump to it.
<F9> = Clear Break, Frame, and Parity errors in the Com port status bar
(text display screen only).
<ALT F9>= Auto adjust to incoming baud rate and clear errors.
<F10> = Toggle logging to disk.
<Esc> = Exit to text mode (if in graphics display mode). Exit to DOS (if text
mode and not logging to disk).
4.5.3.2 Displaying Analog Channels
When in graphics display mode [F5] up to six analog channels may be enabled
by typing <CTRL A>. This will activate a series of questions to format the
analog data for display:
Display Channel Number [0-5]:

Geometrics G-882 Specifications

General

Brand	Geometrics
Model	G-882
Category	Marine Equipment
Language	English