GeoVision GV-AS100 User Manual

x
Elevator Control
GV-AS / GV-EV Controllers provide two types of elevator control.
For GV-AS100 / 1010 / 110 / 1110 / 120 / 210 / 2110 / 2120 / 410 / 4110 / 810 / 8110, the
GV-AS Controller can control access to the elevator call buttons. Users who present the
correct identification card to the elevator reader will be able to use the elevator and can go
any floors. The output relays are connected to the call button of the elevator.
For GV-EV48, a controller especially designed for elevator control, access can be granted to
specific floors. You can configure each identification card to specify the floors it can access.
In this type of elevator control, each output relay is connected to the button of corresponding
floor in the elevator control panel.

GeoVision GV-AS100 Specifications

General

Interface	RS-485
Case design	Housing
Built-in UPS	-
Number of users	40000 user(s)
Maximum number of doors	1 door(s)
Number of Wiegand readers supported	1
Power consumption	200 mA
Operating temperature (T-T)	0 - 65 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	27 mm
Width	96 mm
Height	137 mm
Weight	250 g