GV-ASManager Quick Start Guide
155
5
• Visitor: This card is assigned to a visitor and visitor’s access can be managed
using GV-VMWeb.
• Security: The security card can enable the Security Mode where no cards can
be granted access. Only the security card can disable the Security Mode.
• Handicap: When the handicap card is used, the door will remain unlocked for
the time specified in Lock Reset Time and Held Open Time for handicap card.
To see how to set prolonged Lock Reset Time and Held Open Time for handicap
card users, refer to Chapter 4 Settings, GV-ASManager User’s Manual.
Activation/Deactivate Date: Specify when the card is active or inactive.
PIN Code: Enter a four-digit personal code for the card. The default setting is 1234.
Privilege: Assign one of these privileges to the cardholder:
• Stop Alarm: The cardholder can stop alarm sounds by presenting the card.
• Clear Event: The cardholder can clear alarm events by presenting the card. All
alarms in the Device View window are erased. A record of these alarms is still
kept in the Alarm Monitor.
Access Group: Access Groups control which personnel can access which door and
at what time.
For first-time users of the GV-ASManager, the access group is not yet established.
Select User Define for test run.
Controller: The Controller column displays the associated doors. The selection for
each door will be automatically brought up when one access group was entered.
For first-time user of the GV-ASManager, select 24-hour access for each door for
test run.
4. Present the enrolled card to the reader. Once the card has been accepted, the message
Access Granted will be displayed.
To Next Page
Loading...
Need help?
General
