13
English
6. Attach the plotter to the top four mounting holes of each
support column with bolts, split washers, and flat washers
removed earlier.
7. Remove the tie wrap holding the electrical connector to
the right side wood handle.
8. Remove bolts securing the temporary wood handles to
the bottom of the plotter. Save handles and bolts for
future use.
9. Remove the plastic wrap holding the electrical connector
to the right support column.
10. Attach the plotter to the bottom two mounting holes of
each support column with bolts, split washers, and flat
washers removed in step 4 (Figure 5).
11. Tighten the back panel attaching hardware that was
loosely installed.
12. Connect the male and female electrical connectors on
the right side of the plotter together, and then place them
inside the support column cutout (Figure 5).
13. Install the support column cover in the right column
cutout by pushing it in place.
14. Install right and left nipbar stops on the plotter with
screws (2 places each support column).