Gerber Technology GERBERplotter Infinity Series User Manual

18
English
c) Remove the electrical box rear panel (3) to
access the power switch (4).
d) Set the power switch (4) to the 115 volt
position.
e) Install the electrical box rear panel (3) and
tighten the screws (2).
f) Install the top plotter cover (1).
g) Install a yellow 110 volt power rating sticker
over the yellow 220 volt sticker on the rear.
h) Use a ‘permanent’ marker to write voltage used
on the Voltage Installed portion of the serial
number plate (Figure 9).
Figure 9. Infinity Serial Number Plate (Typical)

Gerber Technology GERBERplotter Infinity Series Specifications

General

Brand	Gerber Technology
Model	GERBERplotter Infinity Series
Category	Plotter
Language	English