Gerber Technology GERBERplotter Infinity Series - Connecting Cables to Rear of Plotter; Figure 10. Plotter Rear Connections

19
English
Connecting Cables To Rear of Plotter
1. Attach the AC power cord to between the power
connector on the rear of the plotter (Figure 10) and the
wall socket.
2. For Infinity 85 (network use), attach the network twisted
pair cable between the plotter network connector and a
10/100-Base T (twisted pair) network connector in your
facility (Figure 10).
3. For Infinity 45 or Infinity 85 (Local use), attach the
RS-232 serial cable between the plotter serial port
(Figure 10) and the computer (workstation) serial port.
Figure 10. Plotter Rear Connections
Key to Figure
1-Network Twisted Pair Cable (Infinity 85), 2-Serial Cable,
3-AC Power Cord
1
2
3