- Alarm LED:
- Editing the current date and time:
The date and time are adjustable. When the battery is disconnected, the date and time are frozen; when the battery
is reconnected, the date and time shown will be from the time the battery was disconnected.
The date and time reflected in the event Log will be taken from the configuration according to the following stepst:
Press (1) and (11) ) simultaneously, then enter the correct PIN number.
Press (3) until the date and time screen appears.
When Date and Time screen appears, press the
button (4). The minutes will start to flash.
Press
(3) or (2) to adjust to the desired setting.
Press the (10) button to confirm the value entered. The hour will begin to flash
. Press (3) or
(2) again to adjust to the desired setting.
Remote start on load
Overload pre-alarm
Common
Common
To Next Page
Loading...