42
43
RENTAL SERIES
ELECTRICAL GENERATOR
• LOAD TEST Mode (Manual):
This operating mode is used to allow the electrical generator to check the state of the mains power or to disconnect
from the mains when an imminent mains failure is detected. When this operating mode is selected, the unit starts up at
no load. To transfer the loads to the unit, press the MCB ON/OFF button (12), and then press the GCB ON/OFF
button (10). At this time synchronization occurs between the electrical generator and the mains for 60 seconds
to assume the loads.
• OFF mode:
The electrical generator will not start. Even if we press the buttons START (5), STOP (6), GCB ON/OFF
(10), the generator will not respond.
Start
I
• Startup:
Press the START button
(5) to start up the electrical generator. When the generator voltage is within the
e
stablished limits, the LED indicator (7) will be lit. Next press the GCB ON/OFF button (10). The loads
will be transferred directly to the electrical generator. To stop the unit, press STOP (6).
Start
I
Stop
0
To Next Page
Loading...