Gesipa PowerBird - Safety Instructions; Intended Use

21
GB
1.6 Intended use
• Engage fully charged battery in correct position into housing.
• Select correct nosepiece (according to table 1.4.) and screw into head.
• Attention: Do not cover the vent holes and do not obstruct the vent holes.
1.5 Safety instructions
Caution:
Following safety rules must be followed for adequate protection against electrical schock, inju-
ries or re hazards:
The riveting tool should be used exclusively to set blind rivets.
• Do not overload the tool; Work within the prescribed work capacity.
• Do not expose the tool to humidity or rain, do not operate the tool close to inammable sub-
stances or gases: Risk of explosion!
• Ensure that the battery is properly secured in the tool handgrip.
• Remove the battery when the tool is not in use and for repair/servicing operations.
• Do not use the tool as a hammer.
• When not in use, keep the tool in a dry closed room, out of reach of children.
• When working with the tool, always carry protection goggles. Personal protection like
clothes, gloves, safety helmet, non slipping shoes, ear protectors and protection against
fall are highly recommended.
• The air inlets for the engine should not be ob structed. Do not introduce anything into them.
• When depositing the tool, make sure that it cannot fall down.
• Use only genuine spare parts for repair.
• Repair work must be carried out by skilled personal. In case of doubt, always send back the
tool to the manufacturer!
• Do not use the tool outside of riveting holes.
The blind rivet could be ejected from the tool. Never turn the tool towards yourself or
towards another person.
• Mandrel container (Part N° 32) must be mounted on the tool during operation.
MG = MEGAGRIP
®
* available as special accessory. Elongated nosepieces and other special nosepieces are
available on request.
MEGA GRIP
®
Ø (mm)
Rivet material Nosepiece Part No.
Jaw
pusher
Part No. Jaws Part No.
4.8
Al/Al, steel/steel,
stainless steel
17/31 MG* 143 4993 5 143 4872
4 143 4240
6.4
Al/Al, steel/steel,
stainless steel
17/41 MG* 143 4865 5 143 4861