Gesipa Taurus 1-4 - Storage; 9 Repairs; 10 Troubleshooting; Blind Rivet Is Not Set

23
GB
9. Repairs
Repairs under warranty are carried out by the manufacturer. Repairs outside the warranty
period should only be carried out by skilled technical personnel. Failure to observe the
assembly and setting procedures and operation by non-skilled personnel may result in seri-
ous damage to the blind rivet setting tool. In case of doubt, always send the blind rivet set-
ting tool back to the supplier or to GESIPA
®
.
10. Troubleshooting
10.1 Blind rivet is not set
Cause Corrective measures
Jaws (No. 5) dirty Clean and oil sliding surfaces (Point 8.1)
Jaws (No. 5) worn Replace (Point 8.2)
Insufficient working pressure See working pressure (Point 4)
Tool stroke too low Top up with hydraulic oil (Point 8.3)
10.2 Spent mandrel is not evacuated
Cause Corrective measures
Spent mandrel container (No. 36) full Empty (Point 7.5)
Wrong nosepiece (No. 1) used Replace according to table (Point 6)
Nosepiece (No. 1) worn Replace
Spent mandrel jammed in jaws (No. 5)
Clean jaws (No. 5) and jaw housing (No. 4)
and oil sliding surfaces; replace if worn
(Point 8.2)
8.4 Storage
The blind rivet setting tool should be stored in a dry place where there is no danger of frost.