FEEDING
SHORT
PAPER
AND
CARDS
(S
"
-7½'
' in length)
NOTE:
(i)
If
paper
is
6½
• or wider proceed with Steps
2 and 3.
(ii)
If
paper
is
narrower than
6½
1
proceed
as
follows:
Raise left hand and right hand Feed Unit Catches
and lift Feed Unit
as
high as possible. Then keeping
the Catches raised, lower Feed Unit until right hand
Catch holds Feed Unit in raised position.
Press Feed Finger Clip inwards and remove Feed
Finger
by
pulling downwards.
Insert studs
of
small Feed Finger into slots
of
Feed
Bracket, bridge 'B' upwards; and press fully upwards.
Raise right hand Catch and lower Feed Unit.
Ensure that Catches clip over Mainshaft
by
pressing
Feed Unit against Mainshaft. Proceed with Steps
2 and 3.
NOTE: The removed Feed Finger can be stored
in
a holder behind Inker Door.
Fitting
Small
Paper
Guides
Fit Small Paper Guides to machine with lugs
'L'
nearest to Side Frames
by
engaging groove
at
top
of
Holders with Feed Unit Support and pressing
fully inwards
to
engage
Mainshaft.
i
,
~
& \ Place papers to be
fed
in
center
of
Feedboard fully
.
i,
forward.
Press Guide Buttons inwards to release Guide
Rods .
. Slide Guides towards stack so that Guide Rods
lightly contact
sides
of
paper.
Move Back Fence until it almost touches rear
of
stack and lower Paper Weight.
CATCHES B
FEED
FINGER
CLIP
L
GUID
E
HOLDER
FEED
UNIT SUPPORT
MAIN SHAFT
lQ
To Next Page
Loading...