Page 5 of 24
<Doc_INS><Doc_502404200><Rel_A><Lang_GB>
When the work is complete, check that
all parts have been installed in accordance with the installation instructions
all screws have been properly tightened
there are no sharp edges on any parts that may come into contact with people
all hoses, pipes and connections are intact and free from defects
all the functions of the machine are working properly. Adjust if necessary.
Carry out an Installation Qualication, an Operating Qualication and a Performance
Qualication according to ISO 15883 before putting the machine into service.
Incorrect use can result in damage to objects and personal injuries
Product liability
Any modication or incorrect use of the equipment without the approval of
Getinge Disinfection AB invalidates Getinge Disinfection AB´s product liability.
This product was manufactured by:
GETINGE DISINFECTION AB
Ljungadalsgatan 11, Box 1505
351 15 Växjö, Sweden
Isolator switch
The machine must be tted with a separate, lockable isolating device in the electric pow-
er supply. The isolating device must be easily accessible on a wall close to the machine.
The installation must conform to and be marked in accordance with local provisions.
Attention symbols
Some of the warnings, instructions and advice in this manual are so important that we
use the following special symbols to draw attention to them. The symbols used are as
follows:
This symbol indicates a warning in the text of the manual. It warns of a hazard
that may lead to more or less severe injury and in certain cases mortal dan-
ger. It also highlights warnings to avoid damage to equipment.
•
•
•
•
•
To Next Page
Loading...
Need help?
General
