1. Press "E" on the transmitter.
2. Enter code 22 with the "+" and "-" buttons.
3. Press "E". "Setup 1" appears on the display.
4. Choose "Output" with the "+" and "-" buttons.
5. Press "E". "Sel. Type" appears on the bottom line.
6. Select "Lin" with the "+" and "-" buttons on the top row.
7. Press "E".
8. Select "4-20 mA" with the "+" and "-" buttons.
9. Press "E".
10. Choose a low value 0/4 mA = 0.000 uS/cm with the "+" and "-" buttons.
11. Press "E".
12. Select high value 20 mA = 500 uS/cm (5 mS/cm for transmitter in high range) with "+" and "-"
buttons.
13. Press "E".
14. Press "+" and "-" simultaneously to log out.
Set the cell constant
1. Press "E" on the transmitter.
2. Enter code 22 with the "+" and "-" buttons.
3. Press "E". "Setup 1" appears on the display.
4. Hold down "E" until "Cell constant" appears on the display.
5. Enter the cell constant with the "+" and "-" buttons for the relevant sensor. See the calibration
certificate that is attached to the machine.
6. Press "E".
7. Press "+" and "-" simultaneously to log out.
Set the damping
1. Press "E" on the transmitter.
2. Enter code 22 with the "+" and "-" buttons.
3. Press "E". "Setup 1" appears on the display.
4. Hold down "E" until "Damping" appears on the display.
5. Enter damping = 10 (25 for transmitter in high range) with the "+" and "-" buttons.
6. Press "E".
7. Press "+" and "-" simultaneously to log out.
Page 130 of 166
<Doc_TEC><Doc_6001341502><Rel.A><Lang_en>
To Next Page
Loading...
Need help?
General
