Need help?Do you have a question about the Getinge 600 Series and is the answer not in the manual?
General| Type | Laboratory Washer |
|---|---|
| Application | Cleaning and sterilization of laboratory glassware |
| Dimensions (W x H x D) | Varies by model |
| Weight | Varies by model |
| Power Supply | Varies by model and region |
| Electrical Supply | Varies depending on the model and region |
| Water Consumption | Varies by program and model |
| Steam Consumption | Varies by program and model |
| Temperature Range | Up to 93°C (199°F) |
| Detergent Dosing | Automatic dosing system |
| Control System | Microprocessor-controlled |
| Programs | Multiple pre-programmed cycles for various applications. Customizable programs available. |
| Compliance | Complies with international standards |
| Certifications | CE |
| Capacity | Varies depending on the model (600/630/650/680). Chamber volumes range from approximately 160 to 530 liters. |
| Water Supply | Hot and cold water connections required. Demineralized water recommended for final rinse. |
Guidance for preparing to install the sterilizer.
Summary of the manual's eight sections.
Information on the environmental impact and disposal of materials.
Explains symbols for switches and indicators on the equipment.
Explains conventions used for clarity in the manual.
Instructions on how to navigate and use the manual effectively.
Overview of the sterilizer's intended use and built-in safety design.
Warns about hot surfaces and pipes, advising caution to prevent burns.
Procedures and rules for locking out the unit during maintenance for safety.
Highlights key safety features like door lockout and obstruction switches.
Describes the main switch for isolating primary power from the sterilizer.
Explains consequences of unauthorized modifications or misuse of the unit.
Initial guidance on unpacking and handling the sterilizer.
Information on weight, lifting equipment, and dimensions for handling.
Procedures for safely uncrating and unpacking the sterilizer unit.
Procedures for safely removing the sterilizer's front panels.
Detailed instructions for removing the sterilizer from its shipping skid.
General advice and cautions before starting installation.
Details required steam, water, and electrical utility connections.
Lists all necessary tools and materials for installation.
Guidance on maneuvering, positioning, and leveling the sterilizer.
Steps to ensure the sterilizer chamber is level for proper operation.
Steps to level the sterilizer door and mounting plate mechanism.
Instructions for installing the kick panel.
Steps for re-installing the sterilizer's front panels.
Instructions for connecting steam, water, and drain lines.
Requirements and procedures for connecting the sterilizer's electrical supply.
Instructions for anchoring the sterilizer for stability and seismic safety.
Details on utility connections, models, and plumbing for steam boilers.
Explains booster pump function, installation, plumbing, and electrical connections.
When a transformer is needed to step down customer power for sterilizer controls.
Information on UPS packages, connections, and mounting.
Overview of the water-saver system and its piping and electrical connections.
When steam boiler feedwater may require treatment based on quality.
Information on available cabinet packages and panel preparation/installation.
Lists drawings for technical data and utility requirements.
Refers to roughing-in and seismic anchorage drawings for installation.
Lists interior and exterior dimensions for the 600 Series Sterilizers.
Requirements for condensate-free steam supply quality for optimal performance.
Recommended feedwater quality specifications for the steam boiler.
Overview of checks to perform after installation for readiness.
Requirement for a final inspection by a Getinge representative before operation.
Customer responsibility for validating custom cycle parameters.
To Next Page
