Getinge 600 Series - Removing the Skid

600 Series Steam Sterilizers
INS 61301607027 Rev A US 3–5
REMOVING THE SKID To remove the sterilizer from its skid:
1. Refer to Figure 3–3. Remove the hardware from the outer beams:
a. 3/8 x 4 in. lag screws (item 1) that attach the outer cross beams to
the outer beams (16 places).
b. 1/2 x 4 in. lag screws (item 2) that attach the leveling foot retaining
blocks to the outer beams. (18 places on 26 in./39 in. skid, 12
places on 51 in. skid).
c. 1/2 x 6 in. lag screws (item 3) that attach the center cross beam and
retaining blocks to the outer beams (8 places).
FIGURE 3–3. SKID HARDWARE
Outer Beam
Outer
Cross Beam
Leveling Foot
Retaining Block
Center Cross Beam
and Retaining Blocks
A07027-BN
1
1
1
1
2
2
2
2
2
2
3
3
3/8 x 4 in. lag screws
1
1/2 x 4 in. lag screws
2
1/2 x 6 in. lag screws
3
Skid Hardware:
Do not remove hardware
on front to back pieces