3.5 LAN
3.5.1 LAN Settings
Configure the gateway address of the Broadband Router. To dynamically assign the IP address for client PCs, enable
the DHCP Server, set the lease time, and then specify the address range.
Valid IP addresses consist of four numbers, and are separated by periods. The first three fields are the network portion,
and can be from 0-255, while the last field is the host portion and can be from 1-254.
IP address: This is the router’s LAN port IP address (Your LAN clients default gateway IP address)
Subnet Mask: Specify a Subnet Mask for your LAN segment.
The Gateway acts as DHCP Server: You can enable or disable the DHCP server.
IP Pool Starting Address: Enter the first address that should be assigned by the DHCP server.
IP Pool Ending Address: Enter the last address that should be assigned by the DHCP server.
Lease Time: Enter the number of hours that a client can use the assigned IP address.
DNS Proxy: To enable or disable DNS Proxy (Domain Name Service).
3.5.2 DHCP Client List
The DHCP client list allows you to see which clients are connected to the Broadband Router via IP address, host name,
and MAC address. You can select static to fix it.
To Next Page
Loading...
Need help?
General