5
SafetyGC 339
à DIN EN 16005 “Power operated pedestrian doorsets – Safety in use –
Requirements and test methods”
à Accident-prevention regulations, especially BGV A1 “General regula-
tions” and BGV A2 “Electrical installations and equipment”.
à The risk assessment and installation of the sensor and the door system in
compliance with national and international regulations and door safety
standards are the responsibility of the door manufacturer.
à Any uses of the device other than those described in this manual do not
correspond to the approved purpose and cannot be guaranteed by the
manufacturer.
1.3 Safety-conscious working
à Secure workplace against unauthorised entry.
à Watch the swivelling range of long system parts.
à Secure the cover/drive panels against falling.
à Attach safety stickers to glass leaves.
à Danger of injury with opened drive. Hair, clothing, cables, etc. can be
drawn in by rotating parts.
à Danger of injury caused by unsecured crushing, impact, drawing-in or
shearing spots.
à Danger of injury due to glass breakage.
à Danger of injury due to sharp edges in the drive.
à Danger of injury by freely moving parts during installation.
1.4 Environmentally conscious working
à When disposing of the door system, separate the dierent materials and
have them recycled.
To Next Page
Loading...
