17
11. Installing Take up reel
1. Loosen the pressure-adjusting nut near the right cabinet, and the rewind tube
can then be removed from the machine
2. Slide a paper tube onto the rewind tube by rotating away from the core stop clip
3. Install the rewind tube onto the positioning sleeves with the core stop clip pointing away
from the Nip Rollers or toward rear of the machine with core stop clip positioned on top
of the rewind tube. (Note: Pay attention to the direction of the core stop clip, or the
application will be affected.)
4. The rewind tube is driven by friction. The friction and tension will be increased with a
left turn of the pressure-adjusting nut, and a right turn will decrease them.
ote:
Adjust the rewind tube pressure-adjustment nut to allow the backing
paper to be removed and the film to enter the rollers evenly
1. Paper tube 2. Core Stop clip 3. Rewind Tube 4. Left side cabinet
5. Positioning sleeve 6. Positioning sleeve 7. Pressure-adjusting nut 8. Right side cabinet
To Next Page
Loading...
