Programming Guide Mitras LX7
EN 2016-11-21 11
2.5 Rainy Days
This function is only available for master and standalone lights. Slave lights follow the
simulations of the master light.
Mitras LX7 allows the programming of "Rainy days". On a rainy day, the lighting intensity is
reduced by an adjustable value.
With this feature, you have the option to set the weekdays for which Rainy Days should be
enabled. Once the days have been selected, the darkening of the day has to be set (0% -
100%).
The Rainy days simulation also takes other simulations into account.
2.6 Thunderstorms
This function is only available for master and standalone lights. Slave lights follow the
simulations of the master light.
Mitras LX7 can simulate an authentic thunderstorm.
When a thunderstorm simulation is in-effect, a slow reduction of all LED channels will occur.
As these channels become darker, the number of flashes will increase. After the
thunderstorm has reached its climax, the lighting is slowly brought back to normal strength,
the flashes become less frequent until finally the thunderstorm is over.
A thunderstorm can be started manually any number of times or automatically up to 4 times
per day. There is also an option to start a thunderstorm at random.
Set the thunderstorm parameters in the Storm menu:
Darkening (0% - 100%) during a thunderstorm
Intensity (1 – 20) of the thunderstorm – Higher numbers, the more flashes are generated
Flash brightness (10% - 100%) – Determines the LED output power during a flash
Thunderstorm/Day – Number of automatically generated thunderstorms in a day (max. 4)
Weekdays – Only on these weekdays there is a thunderstorm
Start 1...4 – A thunderstorm begins at this time
Duration 1...4 – Duration of a thunderstorm (1 to 60 minutes)
Random thunderstorm duration – If you want random thunderstorms, enter a duration (max.
60 minutes) for the random thunderstorm (If you enter 0, randomly generated
thunderstorms are disabled).
To Next Page
Loading...
Need help?
General
