Programming Guide Mitras LX7
EN 2016-11-21 14
3.4 Maintenance
During maintenance and care of the aquarium, it is possible to reduce the brightness of
luminaires. For example, to 80%.
Mitras LX7 offers 4 separately adjustable maintenance programs. The settings must be set via
the GCC.
4 System
All system functions and system settings, e.g. the hardware configuration are pooled here.
The following submenus can be called.
4.1 Factory Settings
After selecting this function, you are asked if you want to restore factory settings. If this is
confirmed, all settings are reset to the delivery state.
4.2 PIN
A personal identification number (PIN) is used to protect the device against unauthorized
changes. Factory default is set to 0000. If the PIN is set to 0000, all changes can be made
without entering a PIN. As soon as the PIN is unequal to 0000, this PIN must be entered
before each setting. This also applies to the PIN change.
4.3 Energy Options
Select between following modes:
All LEDs off - Disables all channels
High Efficiency - High light output with good efficiency - preferred setting
If you forgot your PIN
Switch off the device (disconnect the voltage supply), switch it on again (plug
in the voltage supply again). Immediately, while the status and greetings
screen is displayed, press the left arrow.
You will be asked: Are you going to delete the PIN?
After confirmation with Yes, the PIN is reset to factory default (0000 -
deactivated).
To Next Page
Loading...
Need help?
General
