BEFORE YOU BEGIN:
■ A 12 volt automotive/marine battery or Ghost Controls ABBT Battery Box Kit is required to power the operator.
■ Push-To-Open applications (gate that swings away from the property) will require the Ghost Controls push-to-open
bracket kit (AXPO).
■ If charging your system with the AC transformer, you will need to purchase a 16 gauge stranded low voltage wire to
connect the transformer to the gate operator control board. Up to 1,000 ft. of wire can be used.
■ For installations farther than 1,000 ft. from an AC power source, the Ghost Controls 10 Watt Solar Panel Kit (AXDP)
can be used to charge the battery. Up to 30 Watts of solar power can be used.
CUSTOMIZING YOUR GATE:
Information on additional accessories shown below can be found on the accessory page 66 or visit
www.ghostcontrols.com
INCLUDED IN DTP1 AND DEP2 KITS
ADDITIONAL ACCESSORIES
12V battery required and included
Opens gates up to 20 ft. or 1,000 lbs.
per gate leaf
Low Voltage Wire
(AXLV)
Wireless
Keypad (AXWK)
used for exit
of property
Safety Placards
DTP1 or DEP2
Operator Arm
5 Button
Transmitter
(AXP1)
3 Button
Transmitter
(AXS1)
4
DTP1 SINGLE KIT
©Ghost Controls 2018
To Next Page
Loading...
