Hold the saddle post at the side next to the seat tube so that your fingertip is
again located directly above the clamp. In this position the lower end of the
saddle post must be at least 10 cm below the upper edge of the seat tube.
2. Turn the saddle so that the saddle tip is pointing in the direction of travel.
3. Ensure that the clamp is flush with the frame and that the slots in the saddle
tube and clamp are aligned.
4. Close the quick-release lever.
See section 8.4.2, Opening and closing the quick-release axle on the seat post
clamp.
To Next Page
Loading...