166
6. Pump up the inner tube slightly.
7. Move the tyre to and fro around the circumference at right angles
to the direction of travel. Ensure that the tyre is positioned evenly
on the rim and that the inner tube is not visible at any point.
8. Inflate the tyre up to the prescribed air pressure
(see tyre wall).
9. Mount the wheel in accordance with section 13.1.2,
Install the front wheel or 13.1.4, Install the rear wheel.
10. Check the tyres.
See section 6.1.2, Checking the tyres.
15.6 Electric drive
Malfunction Possible cause(s) Remedy
No display Display not correctly attache Remove the screen and attach
it again
(see BOSCH instructions)
Rechargeable battery pack flat Charge the battery pack
(see BOSCH instructions)
Rechargeable battery pack
broken
Please contact your specialist
bicycle dealer.
Cables damaged Please contact your specialist
bicycle dealer.
Rechargeable battery pack
cannot be charged up
Cables not or incorrectly
connected
Make sure that all connections
are correct
Cables damaged Please contact your specialist
bicycle dealer.
Rechargeable battery pack
broken
Please contact your specialist
bicycle dealer.
Charging device broken Please contact your specialist
bicycle dealer.
Drive not working Fault in the control system Please contact your specialist
bicycle dealer.
Rechargeable battery pack flat Charge the battery pack
(see BOSCH instructions)
Rechargeable battery pack
broken
Please contact your specialist
bicycle dealer.
Cables damaged Please contact your specialist
bicycle dealer.
Speed is over 25 km/h The drive is designed to switch off
at speeds over 25 km/h.
Drive does not supply
enough power
Control system fault Please contact your specialist
bicycle dealer.
Rechargeable battery pack
almost flat
Charge the battery pack
(see BOSCH instructions)
System not calibrated correctly Turn off the drive and turn
it on again - without placing
a load on the pedals
To Next Page
Loading...