Giatsu IKALA - Page 65

USER AND INSTALLATION MANUAL

63
MONOBLOCK IKALAMONOBLOCK IKALA
Fault code Description of the fault
Código de
fallo
Fault code
F1 Compressor IPM error P8 Zero-crossing fault detection
F2 PFC/IPM error PA
Return air sensor temperature abnormal protection
F3 Compressor start error PC Coil tube overload protection(outdoor)
F4
Compressor running out
of step
PE Abnormal refrigerant circulation
F5
Location detection loop
failure
PH Exhaust temperature protection
F6 PCB communication error E0 Sensor on suction pipe error
F7 Coil sensor error (outdoor) E1 Temperature sensor error
F8
Sensor on suction pipe
error
E2
Sensor error on indoor coil tube
FA
Phase current over current
protection
E3
DC fan Feedback failure
FE EE error (outdoor) E4 Communication error
Florida Water-full protection E5 Water-splash motor error
P1
Over-heat protection on top
of compressor
E6
Temperature sensor error(outdoor)
P2
Dc bus voltage Under
voltage protection
E7 Fan motor error (outdoor)
P3 AC Input voltage protection E8 Fan feedback fault
P4 AC over-current protection EE EE error
P5 AC under voltage protection EA Reversing fault of four-way valve
P6
Coil tube overload
protection
Eb Fluoride deciency protection
P7
Defrost protection on coil
tube
- -
If problems not listed in the table occur or recommended solutions do not work, please contact the service centre.
ERROR CODES
12. TROUBLESHOOTING