Giatsu IKALA - Troubleshooting

USER AND INSTALLATION MANUAL

62
MONOBLOCK IKALA
Problem Reasons Solutions
The air conditioner does
not work
There is no electricity.
Check the unit is plugged in, and the socket is
working normally.
The ambient temperature is too
low or too high.
Only use to use the machine with a room
temperature between 7 and 35°C.
In cooling mode, the room
temperature is lower than the
desired temperature; in heating
mode, the room temperature
is higher than the desired
temperature.
Adjust the desired room temperature.
In dehumidication (dry) mode,
the ambient temperature is low.
Ensure that the room temperature is above
17°C for dry mode.
There is direct sunlight. Use curtains to reduce heat from the sun.
The cooling or heating
effect is poor
Doors or windows are open; there
are a lot of people; or in cooling
mode, there are other sources of
heat (e.g. fridges)
Close doors and windows; increase air
conditioning power
The lters screen is dirty. Clean or replace the lter screen.
The air inlet or outlet is blocked.
Clear obstructions; make sure the unit is
installed as per the instructions
The air conditioner is
leaking
The unit is not straight
La unidad no es recta.
Utilice un nivel de burbuja para
comprobar que la unidad está
horizontal, si no se retira de la pared y
Recto.
The drain pipe is blocked
Check the drain pipe to ensure it is not blocked
or constricted.
Compressor does not
work. Overheat protection operational
Wait for 3 minutes until the temperature is
lowered, and then restart the machine.
The remote control does
not work.
The remote control is not aligned
with the direction of the remote-
control receiver.
Let the remote control get close to the air
conditioner, and make sure that the remote
control directly faces to the direction of the
remote-control receiver.
Batteries poor. Replace batteries.
Donotrepairordisassembletheairconditioning.Unqualiedrepairwillinvalidatethewarrantyandmayleadto
failure, causing injuries and property damage. Only use it as directed in this user manual and only perform operations
advised here.
12. TROUBLESHOOTING