Gigabyte G1.Assassin - Page 108

Appendix - 108 -
For the Marvell 88SE9182:
Turn off your computer and replace the failed hard drive with a new one. Restart your computer. To enable an
automatic rebuild in the operating system, you have to set the new hard drive as a Spare drive in the RAID
setuputilityrst.
• Enabling Automatic Rebuild
Step 1:
When the message "Press <Ctrl>+<M> to enter BIOS Setup or <Space> to continue" appears, press <Ctrl> +
<M> to enter the RAID setup utility. On the main screen, press <Enter> on the RAID tab and then press <En-
ter> on Spare Management.
Step 2:
The new hard drive will be displayed on the screen. Press <Enter> or <Space> on the new hard drive to select
it and then press <Enter> on NEXT.Whenprompted,press<Y>toconrm.Thenewharddriveisnowsetasa
Spare drive.
[ Selection]
[ Adapter]
[ Devices]
[ RAID ]
Marvell BIOS Setup (c) 2009 Marvell Technology Group Ltd.
RAIDCong
Port Disk Name Size Max Speed Status
NEXT
Spare Management
* S0 SATA: WDC WD800JD-22LSA0 76.3GB SATA 3Gb/s FREE
ENTER/SPACE: Select, ESC: Back/Exit
ENTER/SPACE: Select, ESC: Back/Exit
[ Selection] [ Adapter] [ Devices]
Marvell BIOS Setup (c) 2009 Marvell Technology Group Ltd.
Create VD
Delete VD
Wipe out disk
RAIDCong
Spare Management
[ RAID ]