Gigabyte G1.Assassin - Clearing CMOS Jumper

Hardware Installation - 34 -
14) CLR_CMOS (Clearing CMOS Jumper)
 Usethis jumper toclear the CMOS values(e.g. date informationandBIOS congurations) andreset
the CMOS values to factory defaults. To clear the CMOS values, place a jumper cap on the two pins to
temporarily short the two pins or use a metal object like a screwdriver to touch the two pins for a few
seconds.
Open: Normal
Short: Clear CMOS Values
• Always turn off your computer and unplug the power cord from the power outlet before clear-
ing the CMOS values.
• After clearing the CMOS values and before turning on your computer, be sure to remove the
jumper cap from the jumper. Failure to do so may cause damage to the motherboard.
• After system restart, go to BIOS Setup to load factory defaults (select Load Optimized De-
faults)ormanuallyconguretheBIOS settings(referto Chapter2,"BIOS Setup,"forBIOS
congurations).
15) HP_PWR (Heatsink LED Power Connector)
The power connector provides power to the LEDs on the North Bridge heatsink.
Pin No. Denition
1 VCC
2 GND
1