Gigabyte G1.Assassin - Page 73

- 73 - Unique Features
B. Updating the BIOS
When updatingtheBIOS, choose thelocation where theBIOS le is saved. The following procedure as-
sumesthatyousavetheBIOSletoaUSBashdrive.
Step 1:
1. InserttheUSBashdrivecontainingtheBIOSleintothecomputer.InthemainmenuofQ-Flash,use
the up or down arrow key to select Update BIOS from Drive and press <Enter>.
Step 2:
TheprocessofthesystemreadingtheBIOSlefromtheUSBashdriveisdisplayedonthescreen.When
the message "Are you sure to update BIOS?" appears, press <Enter> to begin the BIOS update. The monitor
will display the update process.
Step 3:
When the update process is complete, press any key to return to the main menu.
2. Select HDD 1-0 and press <Enter>.
3. SelecttheBIOSupdateleandpress<Enter>.
• The Save Main BIOS to DriveoptionallowsyoutosavethecurrentBIOSle.
• Q-FlashonlysupportsUSBashdriveorharddrivesusingFAT32/16/12lesystem.
• IftheBIOSupdateleissavedtoaharddriveinRAID/AHCImodeoraharddriveattachedto
an independent SATA controller, use the <End> key during the POST to access Q-Flash.
Q-Flash Utility v2.23
Flash Type/Size................................. MXIC 25L1605/1606 2M
Keep DMI Data Enable
Load CMOS Default Enable
Update BIOS from Drive
Save BIOS to Drive
Enter : Run
hi
:Move ESC:Reset F10:Power Off
Q-Flash Utility v2.23
Flash Type/Size................................. MXIC 25L1605/1606 2M
Keep DMI Data Enable
Load CMOS Default Enable
Update BIOS from Drive
Save BIOS to Drive
Enter : Run
hi
:Move ESC:Reset F10:Power Off
!! Copy BIOS completed - Pass !!
Please press any key to continue
Make sure the BIOS update le matches your motherboard model.
• Do not turn off or restart the system when the system is reading/updating the BIOS.
• Do not remove the USB ash drive or hard drive when the system is updating the BIOS.
HDD 1-0 <Drive>
Total size : 0 Free size : 0
0le(s)found