Gigabyte GA-2CEWH - Hammer Configuration

45
BIOS Setup
Figure 2-4: Hammer Configuration
Hammer Configuration
PhoenixTrustedCore(tm) Setup Utility
Advanced
Hammer Configuration Item Specific Help
HT-LDT Frequency: [100MHz]
MTRR Mapping Methods: [Continuous]
Memhole mapping [Hardware]
ECC: [Enabled]
ECC Scrub Redirection [Enabled]
4-bit ECC: [Disabled]
DCAHE ECC Scrub CTL: [Disabled]
L2 ECC Scrub CTL: [Disabled]
Dram ECC Scrub CTL: [Disabled]
F1: Help KL: Select Item + -: Change Values F5: Setup Defaults
Esc: Exit IJ: Select Menu Enter: SelectSub-Menu F10: Save&Exit


HT-LDT Frequency
Manually select HT-LINK frequency.
 Options 200MHz, 400MHz, 600MHz, 800MHz, and 1000MHz (Default values)