- 47 - BIOS Setup
English
PME Event Wake Up
When set at Enabled, any PCI-PM event awakes the system from a PCI-PM controlled state.
This feature requires an ATX power supply that provides at least 1A on the 5VSB
lead.
Disabled Disable this function.
Enabled Enable PME Event Wake up. (Default Value)
Modem Ring On
You can enable wake on LAN feature by the "ModemRingOn/WakeOnLAN" or "PME Event Wake
up" when the M/B has "WOL" onboard connector. Only enabled the feature by "PME Event Wake
up".
An incoming call via modem awakes the system from its soft-off mode.
Disabled Disable Modem Ring on function.
Enabled Enable Modem Ring on . (Default Value)
S3 Resume by USB Device
You can resume the system from USB device.
Disabled Disable this function. (Default Value)
Enabled Enable this function.
Resume by Alarm
You can set "Resume by Alarm" item to enabled and key in Data/time to power on system.
Disabled Disable this function. (Default Value)
Enabled Enable alarm function to POWER ON system.
If RTC Alarm Lead To Power On is Enabled.
Day of Month Alarm : Everyday, 1~31
Time (hh: mm: ss) Alarm : (0~23) : (0~59) : (0~59)
K8n_1001_b.p65 2003/9/19, ¤U¤È 05:1447
To Next Page
Loading...