Hardware Installation- 11 -
English
8) F_PANEL (Front Panel Jumper)
Please connect the power LED, PC speaker, reset switch and power switch etc. of your chassis
front panel to the F_PANEL connector according to the pin assignment below.
1
9
2
10
9) AZALIA_FP (Front Audio Connector)
This connector is supported to connect HD(High Definition) Audio. Check the pin assignment
carefully while you connect the audio panel cable, incorrect connection between the cable and
connector will make the device unable to work or even damage it. For optional audio
panel cable, please contact your local dealer.
HD (IDE Hard Disk Active LED) Pin 1: LED anode(+)
Pin 2: LED cathode(-)
RES (Reset Switch) Open: Normal
Close: Reset Hardware System
PW (Power Switch) Open: Normal
Close: Power On/Off
MSG(Message LED/Power/Sleep LED) Pin 1: LED anode(+)
Pin 2: LED cathode(-)
NC NC
1
2
9
10
HD-
HD+
RES+
RES-
NC
MSG-
MSG+
PW-
PW+
IDE Hard Disk
Active LED
Message LED/
Power/
Sleep LED
Power
Switch
Reset Switch
Pin No. Definition
1 MIC2_L
2 GND
3 MIC2_R
4 -ACZ_DET
5 Line2_R
6 FSENSE1
7 FAUDIO_JD
8 No Pin
9 LINE2_L
10 FSENSE2
HD Audio:
To Next Page
Loading...
