Gigabyte GA-X79-UD3 - Page 38

BIOS Setup - 38 -
M.I.T. Current Status `
This screen provides information on CPU/memory frequencies/parameters.
BCLK/PCIe Clock Control &
Enables or disables the control of CPU base clock and PCIe bus frequency. Enabled will allow the Host
Clock Frequency and Processor Base Clock items below to be congurable. Note: If your system fails
to boot after overclocking, please wait for 20 seconds for automated system reboot, or clear the CMOS
values to reset the board to default values. (Default: Disabled)
Host Clock Frequency &
Allows you to manually set the host clock frequency (which controls CPU, PCIe, and memory frequencies) in
0.01 MHz increments. This item is congurable only when BCLK/PCIe Clock Control is enabled. When you
change the Host Clock Frequency setting, the Memory Frequency (Mhz) setting below will be changed
synchronously.
Important: It is highly recommended that the frequency be set in accordance with the CPU specications.
Processor Base Clock &
Allows you to congure the Processor Base Clock by multiplying the Host Clock Frequency by several
preset host clock multipliers. This item is congurable only when BCLK/PCIe Clock Control is enabled.
When you change the Processor Base Clock setting, the Memory Frequency (Mhz) setting below will be
changed synchronously.
Important: It is highly recommended that the frequency be set in accordance with the CPU specications.
CPU Clock Ratio &
Allows you to alter the clock ratio for the installed CPU. The adjustable range is dependent on the CPU
being installed.
CPU Frequency &
This value is determined by multiplying the Processor Base Clock value by the CPU Clock Ratio
value.
Advanced Frequency Settings `