- 67 - Unique Features
B. Updating the BIOS
In the main menu of Q-Flash, use the keyboard or mouse to select an item to execute. When updating the
BIOS, choose the location where the BIOS le is saved. The following procedure assumes that you save the
BIOS le to a USB ash drive.
Step 1:
1. Insert the USB ash drive containing the BIOS le into the computer. In the main menu of Q-Flash, select
Update BIOS From Drive.
Step 2:
The process of the system reading the BIOS le from the USB ash drive is displayed on the screen. When
the message "Are you sure to update BIOS?" appears, select Yes to begin the BIOS update. The monitor will
display the update process.
Step 3:
When the update process is complete, select Reboot to reboot the system.
2. Select Flash Disk.
3. Select the BIOS update le.
The • Save Main BIOS to Drive option allows you to save the current BIOS le.
Q-Flash only supports USB ash drive or hard drives using FAT32/16/12 le system. •
If the BIOS update le is saved to a hard drive in RAID/AHCI mode or a hard drive attached to •
an independent SATA controller, use the <End> key during the POST to access Q-Flash.
Make sure the BIOS update le matches your motherboard model.
Do not turn off or restart the system when the system is reading/updating the BIOS. •
Do not remove the USB ash drive or hard drive when the system is updating the BIOS. •
Q-Flash Utility v1.00
To Next Page
Loading...
