Gigabyte GA-X79-UD3 - Page 86

Appendix - 86 -
Figure 2
Step 2:
Save changes and exit BIOS Setup.
Figure 3
C. Conguring a RAID array in RAID BIOS
Enter the RAID BIOS setup utility to congure a RAID array. Skip this step and proceed to the installation of
Windows operating system for a non-RAID conguration.
After the POST memory test begins and before the operating system boot begins, look for a message which
says "Press <Ctrl>+<M> to enter BIOS Setup or <Space> to continue" (Figure 3). Press <Ctrl> + <M> to enter
the RAID setup utility.
Marvell 88SE91xx Adapter - BIOS Version 1.0.1.0025
PCIe x2 5.0Gbps
Mode: RAID
[Virtual Disks]
No Virtual Disk!
[Physical Disks]
Adapter 0
Port Disk Name Size Max Speed
S0 SATA: WDC WD800JD-22LSA0 76.3GB SATA 3Gb/s
S1 SATA: WDC WD800JD-22LSA0 76.3GB SATA 3Gb/s
Press <Ctrl>+<M> to enter BIOS Setup or <Space> to continue_
The rst GSATA Controller item controls the "GSATA3 6" and "GSATA3 7" connectors. The second
GSATA Controller item controls the "GSATA3 8" and "GSATA3 9" connectors. The third GSATA
Controller item controls the eSATA ports on the back panel.