Appendix - 90 -
Delete the RAID Array:
To deleted the existing array, press <Enter> on the RAID tab and select Delete VD. When the Delete VD menu
appears, press <Enter> on the array to select it and then press <Enter> on NEXT. When prompted, press <Y> to
conrm (Figure 10).
When the message "Do you want to delete the VD's MBR?" appears, press <Y> to clear
the MBR or press other keys to ignore.
Figure 10
[ Adapter] [ Devices]
Marvell BIOS Setup (c) 2009 Marvell Technology Group Ltd.
[ RAID ]
Create the VD?[Y]
RAID Cong
ID Name Size Level Status Stripe CacheMode
* 0 GBT 152.4GB RAID0 ONLINE 64KB WriteBack
NEXT
Delete VD
Use the Marvell Storage Utility in the Operating System:
With the Marvell Storage utility, you can set up an array or view the current array status in the operating system.
To install the utility, insert the motherboard driver disk, then go to Application Software\Install Application
Software and select Marvell Storage Utility to install. Note: After the installation, you must login the utility
with the same account name and password that you use to login the operating system. If you did not set
the account password before, click Login to enter the Marvell Storage Utility directly. Please note that if you
set the hard drive(s) to IDE or AHCI mode, it is normal that you will not see the hard drive(s) in the Marvell
Storage Utility.
To Next Page
Loading...
