Gigabyte GA-X79-UD3 - Page 97

- 97 - Appendix
Manually Rebuilding RAID 1 in the Operating System •
You can manually rebuild a RAID 1 array without setting the new hard drive as a Spare drive in the RAID setup
utility rst. While in the operating system, open the Marvell Storage Utility and login.
Under Virtual Disk 0, the Property tab displays the
rebuild progress on the right of the Background Activity
Progress item, indicating that the RAID volume is
being rebuilt. When completed, the status will display
as Done.
Step 1:
Under Virtual Disk 0, click the Operation tab and select
Rebuild.
Step 2:
The screen will display the new hard drive. Click on the
hard drive to select it and click the Submit button to
begin the rebuild.
Step 3:
Make sure you have installed the Marvell RAID driver and Marvell Storage Utility from the motherboard driver
disk. While in the operating system, launch the Marvell Storage Utility from Start\All Programs\Marvell Storage
Utility\Marvell Tray, right-click on the icon in the notication area, and select Open MSU. Then login the
Marvell Storage Utility.