- 36 -
No.
Jumper Code Jumper Setting
5.
SSB_ME1
(ME enable/
disable Jumper)
1-2 Close: Normal operation. (Default setting)
2-3 Close: ME recovery mode (S/W).
6.
SSB_ME2
(ME enable/
disable Jumper)
1-2 Close: Normal operation. (Default setting)
2-3 Close: ME recovery mode (H/W).
7.
SATA_DOM0
(SATA port 0
DOM Jumper)
1-2 Close: Use SATA DOM.
2-3 Close: Normal mode. (Default setting)
8.
SATA_DOM1
(SATA port 1
DOM Jumper)
1-2 Close: Use SATA DOM.
2-3 Close: Normal mode. (Default setting)
9.
BMC_FRB3
(Force to Stop FRB3
Timer Jumper)
1-2 Close: Normal operation (Default setting)
2-3 Close: Force to Stop FRB3 Timer
CAUTION! If a SATA type hard drive is connected to the system, please ensure the jumper is
closed and set to 2-3 pins (Normal mode), in order to reduce any risk of hard disk damage.
To Next Page
Loading...
