- 52 - BIOS Setup
5-2-5 SATAConguration
SATA Port 0/1/2/3/4/5
(Note)
Press [Enter] to view the installed HDD devices.
SATA Mode
Select the on chip SATA type.
IDE Mode: When set to IDE, the SATA controller disables its RAID and AHCI functions and runs in the
IDE emulation mode. This is not allowed to access RAID setup utility.
RAID Mode: When set to RAID, the SATA controllerenables both its RAID and AHCI functions. You will
be allows access the RAID setup utility at boot time.
AHCI Mode: When set to AHCI,the SATA controller enables its AHCI functionality. Then the RAID
function is disabled and cannot be access the RAID setup utility at boot time.
Options available: IDE/RAID/AHCI/Disabled. Default setting is AHCI Mode.
(Note) This item is will not appear when the SATA mode is set ot RAID mode.
To Next Page
Loading...
