BIOS Setup - 71 -
5-6 Boot Option Menu
The Boot menu allows you to set the drive priority during system boot-up. BIOS setup will display an error
message if the legacy drive(s) specied is not bootable.
By default, the server searches for boot devices in the following secquence:
1. UEFI device.
2. Hard drive.
Bootup NumLock State
Enable or Disable Bootup NumLock function.
Options available: On/Off. Default setting is On.
Quiet Boot
Enables or disables showing the logo during POST.
Options available: Enabled/Disabled. Default setting is Enabled.
Interrupt 19 Capture
Interrupt 19 is the software interrupt that handles the boot disk function. When enabled, this BIOS fea-
ture allows the ROM BIOS of those host adaptors to "capture" Interrupt 19 during the boot process so
that drives attached to these adaptors can function as bootable disks.
Options available: Enabled/Disabled. Default setting is Enabled.
To Next Page
Loading...
