Gigabyte MC62-G41 - Page 73

- 73 -
BIOS Setup
Parameter
Description
SMU Common Options
(continued)

Fan Control
– Press[Enter]forcongurationofadvanceditems.
– Fan Table Control
»
Options available: Auto, Manual. Default setting is Auto.

EfciencyModeEn
– Options available: Auto, Enabled. Default setting is Auto.

Package Power Limit Control
– Selects use the fused PPT or set customized PPT. **PPT will be used
as the ASIC power limit**
– Options available: Auto, Manual. Default setting is Auto.

APBDIS
– Options available: Auto, 0, 1. Default setting is Auto.

DF Cstates
– Enable/Disable DF C-states.
– Options available: Auto, Enabled, Disabled. Default setting is Auto.

CPPC
– Options available: Auto, Enabled, Disabled. Default setting is Auto.

CPPC Preferred Cores
– Options available: Auto, Enabled, Disabled. Default setting is Auto.

NBIO LCLK DPM
– Press[Enter]forcongurationofadvanceditems.
– NBIO DPM Control
»
This setting controls how the NBIO Power Management is controlled.
»
Options available: Auto, Manual. Default setting is Auto.
NBIO RAS Common
Options
Press[Enter]forcongurationofadvanceditems.

NBIO RAS Global Control
– Options available: Auto, Manual. Default setting is Auto.

NBIO RAS Control
– Options available: Disabled, MCA, Legacy. Default setting is MCA.

Egress Poison Severity High
– CongurestheEgressPoisonHighSeverity.Eachbitsetto1enables
High severity on the associated IOHC egress port. A bit of 0 indicates
LOW severity.

Egress Poison Severity Low
– CongurestheEgressPoisonLowSeverity.Eachbitsetto1enables
High severity on the associated IOHC egress port. A bit of 0 indicates
LOW severity.

NBIO SyncFlood Generation
– The value may be used to mask SyncFlood caused by NBIO RAS
options.
– Options available: Auto, Enabled, Disabled. Default setting is Auto.